Equator PIC 200 N (Black) review

Two zones fit a small counter, but share the power budget

The PIC 200 N is Equator’s portable two-zone induction cooker with a wide footprint and a carry handle. The current manufacturer page identifies the exact model, a black finish, two separate touch-control panels and six levels for each burner. Its stated total output is 1,800 W on a 110 V / 60 Hz / 15 A supply. That total matters more than the promotional description of “independent” burners: the model-specific manual says that when both zones operate, their combined level setting must stay at 7 or below. You can set one side higher while the other is off or low, but you cannot count on both zones delivering their individual peak simultaneously. If your routine needs two pans at once without that shared ceiling, make simultaneous output a hard comparison point.

The six levels are cooking choices, not a published wattage table. The product description calls the burner controls independent, while the manual’s shared-power rule limits the pair. Neither source gives a dependable wattage for each numbered level, so it would be misleading to turn level numbers into precise power claims. A practical profile is one higher-heat task plus a lower setting on the other side, with the exact combination kept within the manual’s combined cap. If your cooking needs a very low and documented wattage or two explicit maximum loads, a different model with a published per-level table may be easier to plan around.

Confirm cookware before relying on both zones

Both zones require compatible magnetic cookware. The listing gives a “pot size” range of 4.7 to 10 inches, and the manual emphasizes a flat magnetic base; those sources do not resolve whether the listed range is measured at the flat base or the pan rim. A magnet test can screen for ferrous material, but it does not certify the actual base diameter or guarantee a fit. Measure the cooking bottom, read the cookware maker’s induction guidance, and check the current manual before treating a small vessel as compatible. The manual allows a maximum combined loaded pot-and-contents weight of 13 pounds, which is an easily missed constraint if you use a heavy cast-iron pan plus a large batch. A standard flat-bottom pan is the intended arrangement; this is not a matched wok system.

Do not confuse inactivity protection with a timer

The PIC 200 N manual describes automatic shutoff after two hours without operation. It does not document a cooking countdown control in the reviewed control sequence, and the product page’s specification table does not list a timer range. So a result that says “two hours” describes inactivity shutoff—not a user-set timer that ends a simmer at a chosen time. If a countdown is essential, treat the maximum as unknown and use a model whose exact manual confirms the timer controls and shutoff behavior. The two display panels and six levels make the basic adjustment visible, but they do not establish temperature-in-degrees mode or food-probe measurement.

Give it countertop clearance and a suitable circuit

The exact manual says not to install the PIC 200 N as a built-in cooktop. It calls for a stable, even surface, ventilation clearance of at least four inches on all sides, a nonmetal surface and enough room for the fan openings to breathe. Its electrical entry is 110 V, 60 Hz, 15 A; the manufacturer lists a six-foot cord, 2.28 × 21.2 × 13.8-inch H × W × D body and 13-pound net weight. It comes with a one-year parts-and-labor warranty according to the page. Confirm the actual rating label and the wall circuit before use; do not plug another substantial appliance into a shared circuit just because the plug fits.

The page advertises RV and outdoor mobility, but the manual specifically warns against use outdoors in rain or bad weather. That caution does not prove the appliance is approved for every dry outdoor, vehicle, generator or battery setup. For the ordinary match here, plan on an indoor countertop and a properly rated mains supply. If mobile or outdoor use is central, ask the manufacturer for current instructions for that exact power source and location rather than relying on broad lifestyle language.

When the PIC 200 N makes sense

This model is worth comparing when you need two normal induction pans at once, can work within a combined 1,800-watt ceiling and have counter space for a 21-inch-wide body. The PIC 100 is the more compact one-pan alternative, with a 1,400-watt maximum; it cannot replace the second zone. Conversely, if a verified countdown timer, a precise minimum-pan-base diameter, individually measured wattage levels or simultaneous full output is essential, the PIC 200 N’s published evidence does not settle that need. The two zones expand what can be cooked at once, but the manual’s combined-level rule is the core tradeoff—not a minor footnote. This is a source-based assessment, not a hands-on or laboratory test, and product-page stock or pricing may change.